Today, Jiangsu Kunzheng cooling tower packing manufacturer will introduce cooling tower packing. Pick out large pieces of waste from the cooling tower. Before cleaning the cooling tower packing, we must first pick out the bulk waste in the tower, because some cooling towers are operating in the open air environment, so it is inevitable that some waste will enter the tower, then the cooling tower packing in the cleaning please what questions? Learn more below!

In the twinkling of an eye, the hot summer is going to pass, the cooling tower packing for a summer must also be stained with a lot of dust and impurities, in this case we need to do it clean, the following is the cooling tower packing factory staff to give you a few warm tips.

Tip 1: First pick out the block waste in the glass steel cooling tower. Finishing the cooling tower parts have to first pick out the block waste of the tower body, because some FRP cooling towers are in the outdoor working environment, it is inevitable that some waste will be presented into the tower body, so finishing once, we must first pick out the block waste. Where is the cooling tower packing mainly used?

Tip 2: The tower body fell off the scale slag to carry out sorting. Working time is long, some of the filling material will embrittlement, descaling, so in the case of finishing, we have to finish the scale slag that falls from the tower, so that the next step can be quickly started.

Tip 3: Use high pressure water pump to continuously clean the filling material and do a good job. In order to better finish the filling material, we can use high pressure water pump to clean the inside of the filling material, after cleaning, many residues inside the filling material will be corroded out.

Tip 4: For the already damaged filling material to immediately expand and replace. Assuming that the working time of the filler is longer, we do not propose that we carry out the finishing of it, and in the case of sorting out the filler, assuming that the filler has already been destroyed, we must immediately carry out the dismantling of it.

The selection of cooling tower packing is very important for the effect of cooling tower packing, it can make the hot water in the cooling tower as far as possible to disperse into a thin water film or water droplets through a series of effects, and then add the touch area of waste hot water air, which makes the water and air touch and then reach the effect of thermal exchange and quality exchange. Therefore, whether the cooling tower packing can fully touch the air and cooling water determines the cooling efficiency of the bump.

This is the whole content of today, if we want to know more about cooling tower packing, welcome to pay attention to cooling tower packing manufacturer Jiangsu Kunzheng.